Q&A Forum
I’ve recently updated my software on yourdyno to the latest version and since doin so I can’t get a correct afr reading on screen, i have an innovate lm2 and the analogue output wire to aux 1 always worked fine until update
my hand held lm2 reads 20.9 but the on screen guage is reading 22.5 I’ve checked the voltage settings etc and all looks good
any ideas or help appreciated as this is driveing me mad
Hi, there is a long time since the last update to the aux readings, so I doubt this is due to the update, unless the aux1 settings did not get transfered from the previous version. But I guess you checked that.
You can still change the min/max voltage vs value to calibrate it if needed
I’ve tried calibrating it that way and if I do it so it reads same as the lm2 at 20.9 once I start logging and the afr changes it’s diesnt match
my lm 2 is giving the right voltage out to same as the manual and default settings
also it’s the first time I’ve updated it and the firmware since I purchased it in June last year