Q&A Forum
Notifications
Clear all
Questions, answers and shared experiences
3
Posts
2
Users
0
Reactions
1,011
Views
Topic starter
What's this about Pro Software?
What's different between it and the current software that works with the OG YourDyno box?
Posted : 10/11/2022 1:47 am
Hi,
The pro software is the same as the standard YourDyno software, plus the following:
Support for 24 bit load cell resolution, 8 aux channels, 8 thermocouples, 6 RPM/Frequency channels (can be used for RPM or frequency-based sensors like flow meters), built in CAN bus support for both CAN read and CAN write (can output data channels to data loggers, ECUs, gauge displays, etc). And support for 2 stepper motors.
So it is basically what you need to run the Ultimate unit!
This post was modified 2 years ago by Jostein
Posted : 13/11/2022 2:06 pm
Topic starter
Basically what I thought. Thanks.
The Ultimate, does it only work with 2 load cells? It seems that it can only be ordered with 2 or 4 load cells.
Posted : 14/11/2022 6:18 am