Q&A Forum
Notifications
Clear all
Topic starter
Hi,
After seeing that the software reads torque in Nm it occurred to me that the load sensors are probably rated in Nm also? The largest listed on your site is a 1000 Nm I assume. Are there larger units available? perhaps a 1400 Nm? (Approx 1000 Ft/lb)
Thanks
Posted : 06/11/2016 10:42 pm
Hi,
I use American made load cells, and they are rated in lbs. If you go to http://yourdyno.com/choosing-the-right-hydraulic-pump/ you can enter your data and calculate the load cell size you need. You typically choose the next level up from the calculated size.
If you need another size than what is available in the webshop just let me know!
Regards,
Jostein
Posted : 06/11/2016 11:09 pm