Q&A Forum
Topic starter
Is there a setting to adjust how far the unit will look for the load control end stop sensor ? Currently right now it tries and turns one revolution and fails. I need it to move about 3 revolutions to hit the end stop. Any help would be greatly appreciated. Also wouldn't hurt to speed it up a smidge while auto zeroing.
Posted : 01/03/2026 6:02 am
The stepper moves a maximum of 1600 steps to find the zero position. This is 4 full revolutions at 400 steps/rev, or 8 if you use 200 steps/rev. If it has not found the zero by then it is considered an error. In normal operations, the zero will be found in just a few steps.
Posted : 02/03/2026 9:06 am
Topic starter
I changed my stepper driver settings to 200 steps per rev and fixed the problem. I had a feeling it was step limit related.
Posted : 03/03/2026 2:44 pm