Q&A Forum
Notifications
Clear all
Topic starter
Trying to figure out dyno losses so I can get accurate wheel hp & torque. I watched the YouTube video https://youtu.be/9Dqe-raCBho?si=rCGClQNVPHclKvOl (hope link is attached righ).
When getting ready to speed up rollers, what kind of run do you choose? Or is it done through the wizard?
Posted : 08/01/2024 7:18 am
You can set the brake mode to Off. We don't really care about the power in the acceleration phase, so any mode will do, but Off is normally the mode to use.
Make sure that you disconnect whatever is accelerating the rollers upon reaching max RPM, such that the dyno decelerates on its own.
The Wizard is not used in the losses measurement.
Posted : 08/01/2024 8:27 am
Abuen reacted