Q&A Forum
I got a dynocom 1800 inertia dyno want to connect the roller drum brake to the software not sure how this in done . I have a 12v? (Or at least a 12v battery will turn it on) Mac valve on the air line to the brakes . What’s needed to do this and how? I would like it to slowly apply brakes after a run and apply 100% when loading car on the dyno .
Hi, is that a air operated brake? Post a few pictures.
Yes air operated
I have a dynocom dc15000 with an air brake..... my mac valve needs 12 volts I believe. how do I hook this up and configure this?
You use a KmTronic USB relay. These can be controlled from YourDyno, either with a button press or a data channel threshold. See USB Relay Controller - Four Channel (kmtronic.com). The 8 channel relay box is also supported.