Q&A Forum
Notifications
Clear all
Topic starter
Hi,
I just bought a yourdyno box. I was able to calibrate and things seemed to be working (no engine yet), but I was able to get an rpm input with your trigger wheel.
The next day I came out to continue to work on it and it won't connect, or show up in the device manager when I plug in the USB cable. The 5V outputs are producing 5V. I've tried a different usb cable and different computer. The green D2 light on the board is on.
What can I do to get this working again?
Thanks,
Dave.
Posted : 10/12/2021 10:04 pm
Hi, you sent me a mail about this and I send two replies but it seems you did not get them.
Open the unit, press the button while connected to the PC with no sensors connected. The blue LED should blink. Now you can download firmware again. Let me know by mail at jostein@yourdyno.com if it does not fix it.
Posted : 11/12/2021 6:51 pm