Q&A Forum
I have a Dyno Dynamics motorcycle brake dyno which I recently replaced with the yourdyno system, however due to setup issues & a lot of worked booked I have reverted back to the Dyno Dynamics controller until I have time to fix the problems I have . I am wondering if it is okay to wire 2 control systems to the one brake , everything else separate just the 2 separate brake looms to each system , to be used individually not at the same time ?
Hi,
Only one system must be connected at any one time, this is the most important. So disconnect everything from Dyno Dynamics when using YourDyno and vice versa.
I am not sure I understand what you mean by 2 brake looms. Does it mean the YourDyno eddy brake power supply is connected to the brake at the same time as the Dyno Dynamics power supply? Don't do that.
Okay thank you all I needed to know at this stage