I have everything up and running have double and triple checked everything i can think of I'm completely new to dynos. having an issue with very low hp/tq readings and rpm on the run screen is matching the engine rpm but then when i go look at the graph it will read around half max rpm Eg ran truck up to 5800rpm checked on my data log of the ecm and watched the run screen match but when i go look at the graph it only shows max rpm of 2621 and says the truck makes 102hp engine the truck should be i think in the 275 range factory rates them at 360hp engine. sorry I'm at a loss here its a complete learning curve for me i have checked the speed sensor for the tone wheel and set air gap to .040 but it seems to be reading correct on the run screen compared to actual engine rpm i have calibrated the load cell a few times and i believe my MOI input is correct and i got it from the mustangs use manual.

Thanks