Q&A Forum
Notifications
Clear all
Topic starter
Hello,
So on intial setup I bought the MSD tach sensor to run through an optocoupler so I could read ignition RPM. But turns out I didnt need it with the newer YD unit!
I want to use the sensor to measure injector pulses, but cannot find the diagram for wiring it to the YD unit via the optocoupler. And what settings to change in the software to run it.
Can anyone help?
Thanks
Paul
Posted : 10/05/2024 10:18 am
Do you mean to read the duty cycle of the injector pulses? That is not possible today.
Posted : 10/05/2024 11:43 am