Q&A Forum
Hello,
Seriously considering this as a control for two Mustang MD-140t eddy current PAUs I picked up second hand. I need two of these ganged together to manage the HP and speed of the engines I work with using a reduction ratio.
My end goal is steady state testing and calibration, ramp runs, and automated test sequences. I downloaded the software, but can't see if it supports these functions.
Somewhat self-answered. Found the test sweeps for RPM and brake.
I understand there is no throttle control to allow for that aspect, but if the desire is to cycle the engine at high power levels by ramping up and coasting down without the brake. Would this be possible?
Yes, you an create any curve in the RPM sweep setup (ctrl-click to add a point on the curve), or you can set up one sweep and click on Automatic restart so you can run it over and over again.