Q&A Forum
You can set the brake mode to Off. We don't really care about the power in the acceleration phase, so any mode will do, but Off is normally the mode t...
F12-40 is 6 coils, correct? That means 72V in total if all coils are in series. Yes, you can use the YourDyno power supply to power this brake. ...
Hey folks, YourDyno software version 3.3.67 (beta) was released today. A number of minor improvements here and there! Changes: Saving of manua...
Hi @2smoke, did you figure out what the problem was?
@six_shooter You can turn over to light mode when printing and turn back to dark mode. It could be automatic in the future. Dark mode on everything ...
@drmototuning send me your config file to jostein@yourdyno.com. I will take a look at your options.
Hi, Do you have two loadcells in this setup? If it is a 2WD chassis dyno, you should normally only have 1 load cell. In that case, turn off Load ce...
Hi. Set the circumference of the drum here: Plugins->Speed and Distance. The circumference is Diameter(meter) * 3.14
@abuen you can try the timing light, but the proper clamp from Innovate is likely better.
Hi, For the Eng RPM you can connect an inductive clamp, which is much better than the MSD. This one for example from Innovate Motorsport. With this ...
@abuen thanks for posting, that is quite interesting. We don't have support for Jetdrive today, the closest you get is CAN bus, where the ECU and Your...
@radics1 there must be something different in the options. Send me the backup'ed options file from 3.3.61 and 3.2.138 and a raw file and I can take a ...
@osi great to hear. I have seen that a few times before. Windows, in its wisdom, sometimes assigns the same COM port number to two different devices. ...
On the RPM side there is an important rule: The RPM sensor needs to read the RPM of the brake. If the RPM sensor is on the brake already, then we don'...
@osi I just checked that and cannot reproduce it. Is it reproducible on your end? If so, send me a mail on jostein@yourdyno.com and let's continue the...