Q&A Forum

-ww-
@ww
Member
Topics: 7 / Replies: 11
Topic
Reply
RE: Any idea is my Hub dyno maxing out?

Can i put maximum pulse widht up to 100% ? Now its only 60%. 2pcs CC160 should able to brake 3200Nm from hubs and with 3.91 ratio there is only ~2...

3 years ago
Reply
RE: Aux 2 bug?

@adminFinland, can i change it somewhere?

3 years ago
Topic
3 years ago
Replies: 2
Views: 666
Reply
RE: Powersupply settings?

Just looked and i dont have an analog input, its optional. How should i figure out duty cycle and frequency?Signal period 416 ms, am i right? Maximum ...

3 years ago
Reply
RE: Powersupply settings?

@adminWhy analog rather than PWM ?

3 years ago
Reply
RE: Power sweep mode

I have also some trouble with power sweep. Using hub dyno, two Telma CC160.I think that low inertia is the cause of the problems, and tried to adjust ...

3 years ago
Topic
Topic
Reply
RE: Telma retarder power supply options?

One question, if i wire new coils to series, how i check the polarity? With compass, or is there any difference how i connect them...? E: Second que...

4 years ago
Reply
RE: Telma retarder power supply options?

More:3000W Switching power supply output 72v 80v 90v 110v 200v dc, INPUT 110/220VAC AC-DC SMPS POWER SUPPLY Switching Power Supply adjustable voltage0...

4 years ago
Page 1 / 2
Select your currency