Q&A Forum

devolkswagenman
@devolkswagenman
Member
Topics: 1 / Replies: 32
Reply
RE: MAHA LPS 13 project. Many questions

This looks a good solution to me but the bar type is less work to make it work but I don't know if the bar type is lineair enough.  mainline-d...

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

After change the method of calibrating te load cell I stil have problem with the HP numbers. Small cars up to 100 HP is no problem but when I have a c...

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

@thdyno Here you go! (Sorry for the late reply)  E2303799-EE70-40F4-BEAD-199DF55C1FB2.jpeg

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

When there is no RPM signal the output is 5 volt continious between ground and signal.

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

Today i had an idea. I have a RPM sensor for the CO tester that works with a pietso element. It is magnetic en you can put it on the engine and wil me...

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

Ramp up brake before run starts is at 0% and the frequency is 10Hz. I use the same settings in the older software as the last update. I also checked ...

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

@admin Kp=1,4 Ki =0,5 Kd =0.0 When i install the older version 3.2.59 everything works fine. But then i use the tacho setting to got engine r...

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

Changed the PID but i got still the same problem. I am running the latest software (beta) and firmware version.

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

I got the plugins working. And recalibrated the loadcell with a new made bracket for the weights because i had wrong power numbers. Now i have the pro...

3 years ago
Reply
RE: MAHA LPS 13 project. Many questions

I have to take a look at the shop. I can't remember. I have a wire diagram of the LPS 13. What I did is looking at the colors of the wire of the cell ...

3 years ago
Reply
RE: No plugin works with current version of yourdyno.

Same problem here. When i go back to older version of yourdyno the plugings work fine.  plugin-error.jpg

4 years ago
Reply
RE: MAHA LPS 13 project. Many questions

I would like to buy a OBD scantool for yourdyno. But what is the best thing to do? A bluetooth one ore with a USB cable? Which one has the best respon...

4 years ago
Reply
RE: MAHA LPS 13 project. Many questions

I did send you a file and config by Email.

4 years ago
Reply
RE: MAHA LPS 13 project. Many questions

That is no problem. Do i need to uninstall the beta version?

4 years ago
Reply
RE: MAHA LPS 13 project. Many questions

@admin Thank you. I have installed that. I now running the latest beta software because of the dutch translation and there is a bug with te window of ...

4 years ago
Page 1 / 3
Select your currency