Q&A Forum

chipg1956
@chipg1956
Member
Topics: 6 / Replies: 10
Topic
2 years ago
Replies: 1
Views: 456
Reply
RE: MAHA LPS2000 conversion

@thdyno What do you use for the lever length when calibrating? The mounting on the inside? The mounting on the frame? Or the middle of the load cell...

3 years ago
Reply
RE: Thermocouple wired to aux input amperage requirement

Yes, that is what I had suspected....I believe I will need a separate power source. I speculate the amperage requirements are minimal? Perhaps 500m...

3 years ago
Reply
RE: MAHA LPS2000 conversion

@danny_530 Were you able to use that load cell? I have something similar and am converting a Maha/Sun emissions dyno to a small engine dyno. Chipg19...

3 years ago
Reply
RE: Eddy brake RPM range

It seems that my best option is to purchase your power supply. However I have a concern on how to wire the input. I see that it is designed to opera...

3 years ago
Reply
RE: Eddy brake RPM range

Does it matter if I use AC or DC on the analog signal?

3 years ago
Reply
Reply
RE: Eddy brake RPM range

I am not sure that the controller is PWM calling it that was ignorant on my part. I do not even know what a PWM is, I am very new to this and it is s...

3 years ago
Reply
Near compleation.

I am near completion with this project. Now at the point that I most feared, hooking everything up without frying my purchase. I am enclosing photos ...

3 years ago
Reply
RE: Eddy brake RPM range

The Dyno was sold by Snap On Tools / Sun originally to check emissions and do driver simulations. Model is RG240P also as EESE101A. It is portable...

4 years ago
Topic
Page 1 / 2
Select your currency