|
Any number that ensures at least 200 pulses per sec at the l... In forum Questions, answers and shared experiences |
19 hours ago |
|
This is an old topic but I see it pops up in search results.... In forum Questions, answers and shared experiences |
20 hours ago |
|
No go for a hall sensor or an encoder for the brake RPM. In forum Questions, answers and shared experiences |
5 days ago |
|
For that sensor I think the npn is the correct type. It was ... In forum Questions, answers and shared experiences |
5 days ago |
|
That may work. You need one that triggers on ferrous materia... In forum Questions, answers and shared experiences |
5 days ago |
|
Hi, No, that does not work. You need a digital sensor, such ... In forum Questions, answers and shared experiences |
5 days ago |
|
Hi, sure, you just grab the label of the graph you want to m... In forum Questions, answers and shared experiences |
2 weeks ago |
|
OK. Do check out the CanTool +EcuMasters option too, it is g... In forum Plugins discussions, requests and sharing |
2 weeks ago |
|
Yes, I will update it. And I will check if it is possible to... In forum Plugins discussions, requests and sharing |
2 weeks ago |
|
Hi, yes you are correct. The VM167 has 5 analog inputs. For... In forum Plugins discussions, requests and sharing |
2 weeks ago |
|
You can wire two brakes in series and get 192v. The drawback... In forum Questions, answers and shared experiences |
3 weeks ago |
|
Hi, yes the average current is set by the brake and the volt... In forum Questions, answers and shared experiences |
3 weeks ago |
|
@bmgjet yes sure. I will make a manual target RPM writable. ... In forum Plugins discussions, requests and sharing |
3 weeks ago |
|
You have an inertial dyno? It is more common on a brake dyno... In forum Questions, answers and shared experiences |
3 weeks ago |
|
Yes, same graphs, but you need to zoom such that you see the... In forum Questions, answers and shared experiences |
3 weeks ago |
