Additional hardware support

KMTronic usb relay support, includes automatic turn on and off based on other channels. For example turn on a relay when RPM is higher than 0. Buy the KMTronic device here: USB Relay Controller - Four Channel (kmtronic.com)    ▼

PHT200 from Dracal is a USB environmental sensor. It can be used instead of the built in environmental sensors in the case where the YourDyno box is built into a cabinet for example. Or if you want to measure temperature, humidity and air pressure on a specific location. This plugin provides support for the PHT200. https://www.dracal.com/store/products/usb_pth200/index.php The plugin is installed via the YourDyno installer. Source code is provided below for inspiration and can be used as a starting point of other YourDyno plugins.  ▼

Adds Support for CAN Bus Nodes to YourDyno. This can be used to read any CAN bus device; sensors or ECUs or any device compatible with CAN. There are many CAN bus compatible sensors available off the shelf. It can for example read 8 thermocouples through the ECUMasters EGT to CAN, there are CAN bus Wide Band Lambda controllers, etc. If you really want a lot of channels, check out this option: AEM 22 Channel CAN Sensor Module, or similar units. As you can see there is almost endless opportunities to add more channels to your Dyno system via CAN. It requires this CAN to USB converter: https://www.aliexpress.com/i/32841301438.html with this driver: USB_CAN TOOLSetup(V2.12).exe See this video for more information. https://www.youtube.com/watch?v=P5y8QPqW0vg The plugin is installed via the YourDyno installer.     ▼

OBD2 SCANTOOL Plugin by BMGJET This adds support to read any channel over OBD2 into YourDyno. Standard ELM327 is supported (USB/Bluetooth). Also OBD2 Honda OBD1 QD2/QD3/ISR over UART. Check this thread for more info: https://yourdyno.com/community/pluginforum/plugin-scantool/ The plugin is installed via the YourDyno installer. Source code is provided below for inspiration and can be used as a starting point of other YourDyno plugins.  ▼

This plugin provides support for the cheap HID USB Relay Board found on ebay. With this plugin and the board,  You can trigger 1 to 8 relays to control external devices. Ebay Source for board. https://www.ebay.com/itm/1-2-4-8-Ch-5V-10V-USB-Relay-Programmable-Computer-Control-Relay-For-Smart-Home/192208103778 The plugin is installed via the YourDyno installer. Source code is provided below for inspiration and can be used as a starting point of other YourDyno plugins.  ▼

NOTE: You MUST install the driver for the VM167 board before attempting to install the plugin. Download the driver here. YourDyno will crash if you don't install the driver. This is not YourDyno's fault, it is the way that Velleman made their API. This plugin provides support for the inexpensive VM167 board. With this plugin and the board, 5 more analog channels are added, as well as support for 4 outputs. See https://www.velleman.eu/products/view/?id=384006 for details about the board. The plugin is installed via the YourDyno installer. Source code is provided below for inspiration and can be used as a starting point of other YourDyno plugins.  ▼